Home > Purchasing > Hardware
Sort By:
Page of 1
Vehicle Sticker Antenna (pencil, orange) Molex to Molex Jumper
Vehicle Sticker
Cost: $1.40
eFleetSuite Electronic Driver Logs on Board Vehicle Sticker Taoglas Cellular and GPS antenna, model TG.08.0113



8-pin Molex to Molex adapter cable which flip-flops standard 1708 and 1939 pins. For use in 2016 and newer Kenworth and Peterbilt trucks.



Molex to Molex Jumper - Type 2 Display Mount OBDII to 9-pin Deutsch adapter
Display Mount
Cost: $32.00
8-pin Molex to Molex adapter cable which removes the standard 1708 pins to eliminate 1939 noise on these pins in some Kenworth and Peterbilt trucks.



RAM mount is used to mount A317 hardware in the cab. RAM Mounting Systems is a world leader for design and manufacturing of mounting applications. Includes screws and washers to connect to the A317. Screws for attaching to the dash are not included.
9-pin Deutsch Type 1 (black) male to Volvo OBDII female adapter. Used in 2014 and newer Volvo/Mack Trucks.



DB44 to Molex coiled cable Type 2 Deutsch adapter 6-pin Deutsch adapter
DB44 to Molex interface cable for A317 display



9-pin Deutsch Type 1 (black) male to 9-pin Deutsch Type 2 (green) female adapter



9-pin Deutsch Type 1 (black) male to 6-pin Deutsch (gray) female adapter>. Found in most older trucks from 2000 to 2005.



24-Month Extended Warranty - A317 display 9-Pin Vehicle Y Interface Cable Combination 6-pin 9-pin Interface Cable
24 Month extended warranty for A317 display. This is an extension of the standard warranty, which is 12 months from purchase of the device. Warranty is limited to the A317 display and does not cover accessories. Extended warranty must be purchased at least 30 days prior to expiration of the original warranty. All warranties cover manufacturing defects and hardware failures. Physical damage is not covered by warranty.
9-Pin Type 2 (green) Y-vehicle interface cable for A317 display.



Wiring harness that will accommodate both 6-pin and 9-pin diagnostic ports.



A317 Hardware Kit - No Device Included
Full accessory kit minus the logging device. Includes DB44 to Molex coiled cable, 9-pin Deutsch to Molex wiring harness, RAM mount, 2 antennas, 2 zip ties, sticker, installation guide, and user guide.